Avital 2200 Manuel d'utilisateur télécharger pdf (Page 15)

1111

2004 Directed Electronics, Inc.

rity system is triggered by an open door for three, full 30-second

cycles (one and one half minutes), the system will bypass the

doors until the trigger ceases.

NNOOTTEE

: Arming and disarming the system does not reset the NPC

™

. The only

ways to reset a bypassed zone are for that zone not to be triggered for

60 minutes or to turn the ignition key on. When testing your system, it

is important to remember that NPC™ can cause zones to be bypassed and

appear to not work. If five chirps are heard when disarming the system,

NPC™ has been engaged. To clear the NPC™ memory, simply turn the igni-

tion key on.

DDiiaaggnnoossttiiccss

The microprocessor at the heart of your system has the ability to

constantly monitor all of the switches and sensors connected to it.

It can detect any faulty switches or sensors and prevent them from

disabling the entire system. It can also record and report any trig-

gers that occur when you are away from your vehicle.

If the system is armed at the same time that an input is active

(door opening, sensor triggering, etc.), you will hear one chirp to

indicate arming and a second chirp a few seconds later to indicate

Bypass Notification. A Bypass Notification chirp means that the sys-

tem ignores the input that was active when the system was armed,

until that input ceases. Three seconds after that input ceases, the

system will resume normal monitoring. For example, if your vehicle

AArrmmiinngg DDiiaaggnnoossttiiccss

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Avital 2200 Manuel d'utilisateur Page 15