Avital 4111 Guide d'installation télécharger pdf (Page 7)

Tach Learning

To learn the tach signal:

1. Start the vehicle with the key.

2. Within 5 seconds, press and hold the Valet (Control) button.

3. After 3 seconds the system LED will light constant when the tach signal is learned.

4. Release the Valet (Control) button.

Important: This unit can learn the tachometer with the

analog input or through D2D using an interface mod-

ule. The unit conﬁrms which source is used.

When programming tach learning with:

• Analog, the parking lights ﬂash one time

• D2D inerface module, the parking lights ﬂash twice

If the tachometer input on the system is connected to the vehicle, the D2D tachometer input will be ignored.

Virtual Tach

Note: Virtual tach is not recommended for diesel vehicles.

To program Virtual Tach:

1. After the install is complete, remote start the car.

2. If the car does not start on the ﬁrst attempt, let the remote start attempt again.

3. Once the car starts, let it run until the parking lights come on.

4. When the parking lights come on, shut off the remote start with the remote - that’s it! Virtual Tach is pro-

grammed.

Virtual Tach handles disengaging the starter motor during remote starting – it does not address over-rev. If

the customer wants to have the over-rev protection capability, the tach wire must be connected. This may

involve more installation shop charges than initially quoted.

Important: If the Virtual Tach mode over cranks or

doesn't crank the vehicle long enough to start and run

the car, use the Bitwriter to add or subtract the starter

output time. You can adjust the output time in incre-

ments of 50msec of the learned time using the Bitwriter.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Avital 4111 Guide d'installation Page 7