Avital 4111 Guide d'installation télécharger pdf (Page 18)

Heavy gauge relay interface

The heavy gauge wires are used to energize high current circuits in the

vehicle. It is crucial that these connections are made correctly so that

they are capable of handling the current demands. For this reason,

scotch locks, T-taps and other such connectors should not be used.

PINK (+) OUTPUT TO IGNITION CIRCUIT

Connect this wire to the ignition wire in the vehicle.

PURPLE (+) OUTPUT TO STARTER CIRCUIT

Connect this wire to the starter wire in the vehicle.

ORANGE (+) OUTPUT TO ACCESSORY CIRCUIT

Connect this wire to the accessory wire in the vehicle that powers the

climate control system.

4 & 6

RED (+) (30A) HIGH CURRENT 12 INPUT

Remove the two 30 amp fuses prior to connecting these wires and do

not replace them until the satellite has been plugged into the control

module. These wires are the source of current for all the onboard re-

mote start relays and the main unit. They must be connected to a high

current source. Since the factory supplies (+) 12V to the key switch that

is used to operate the motor, it is recommended that these wires be

connected there.

Note:

If the factory supplies two separate (+) 12V feeds to the igni-

tion switch, connect one RED wire of the satellite to each feed at the

switch.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Pas de commentaire

Avital 4111 Guide d'installation Page 18