Avital 4111 Guide d'installation télécharger pdf (Page 33)

Once the Program switch has been pressed and released the desired

number of times, press it once more and

HOLD

it. After a second, the

LED will ﬂash to indicate which feature you have accessed. For ex-

ample, groups of eight ﬂashes would indicate access to Factory Disarm

Pulse Count. (Menu 1, Feature 8).

Transmit.

The remote control is used to select the

desired setting. Press the button on the remote con-

trol to set the feature option. The ﬁrst press selects

Option 1 with one Horn Honk. Press again to select the next available

option, the number of Horn Honks equal to the option number.

Release.

The Program switch can now be re-

leased.

You can advance from feature to feature by pressing and releasing the

Program switch the number of times necessary to get from the feature

you just programmed to the feature you wish to access. For example,

in Menu One, if you just programmed feature 1-3 to off, and you want

to program the next feature 1- 4, release the Program switch. Press and

release it once to advance from Feature 1-3 to Feature 1- 4. Then press

it once more and

HOLD

it. The LED will ﬂash in groups of 4 to conﬁrm

that you have accessed Feature 1- 4.

The learn routine will be exited if any of the following occurs:

The ignition is turned on.•

The Program switch is pressed too many times.•

More than 25 seconds elapses between programming steps.•

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

Pas de commentaire

Avital 4111 Guide d'installation Page 33