Avital 4111 Guide d'installation télécharger pdf (Page 26)

Virtual tach learning

To program Virtual Tach:

After the install is complete, remote start the car. 1.

If the car does not start on the ﬁrst attempt, let the remote start at-2.

tempt again.

Once the car starts, let it run until the parking lights come on.3.

When the parking lights come on, shut off the remote start with the 4.

remote - that’s it! Virtual Tach is programmed.

Virtual Tach handles disengaging the starter motor during remote start-

ing – it does not address over-rev. If the customer wants to have the

over-rev protection capability the tach wire must be connected. This

may involve more installation shop charges than initially quoted.

Important: If the Virtual Tach mode over cranks or doesn’t crank the

vehicle long enough to start and run the car, use the Bitwriter to add or

subtract the starter output time. You can adjust the output time in incre-

ments of 50mSec of the learned time using the Bitwriter.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

Pas de commentaire

Avital 4111 Guide d'installation Page 26