Avital Tornado 2 Guide d'installation télécharger pdf (Page 15)

Relay for Positive (+) Disarm Wire

H1/2

GREEN/WHITE FACTORY REARM

This wire sends a negative pulse every time the remote start shuts down

or the doors are locked. This can be used to pulse the arm wire of the

vehicle’s factory anti-theft device. Use a relay to send a (-) or (+) pulse

to the arm wire.

H1/3

YELLOW (+) IGNITION OUT (TO ALARM)

As a stand-alone system:

The H1/3 YELLOW wire should not be con-

nected to anything.

As an add-on car starter:

If connected, disconnect the ignition/ac-

cessory input of the remote controlled security or keyless entry system.

Connect the H1/3 YELLOW ignition output to the ignition/accessory

input of the remote controlled security or keyless entry system. The wire

will prevent the host system from sensing that the ignition is on during

remote start operation.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Pas de commentaire

Avital Tornado 2 Guide d'installation Page 15