Avital Tornado 2 Guide d'installation télécharger pdf (Page 18)

H1/8

BLACK (-) chassis GROUND connection

We recommend that you do not use a factory ground. Ground all

your components to the same point in the vehicle, (preferably the kick

panel). Scrape away any paint and use a factory bolt or make your

own ground with a self-tapping screw and a star washer.

H1/9

WHITE (+/-) LIGHT FLASH OUTPUT

Important:

Do NOT connect this wire to a negative

vehicle light ﬂash wire before changing the program-

ming jumper to the negative polarity position or dam-

age to the vehicle light circuit may occur.

As factory conﬁgured, the H1/9 WHITE wire should be connected to

the (+) parking light wire. If the light ﬂash polarity jumper is moved to

the (-) position (refer to the Programming Jumper section of this guide),

this wire then supplies (-) 200mA output.

Note:

For parking light systems that draw 10 amps or more, the

jumper must be placed to the (-) light ﬂash output (refer to the Program-

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Pas de commentaire

Avital Tornado 2 Guide d'installation Page 18